Ads
related to: oxygen gauge for cutting torch
Search results
Results From The WOW.Com Content Network
For cutting, the setup is a little different. A cutting torch has a 60- or 90-degree angled head with orifices placed around a central jet. The outer jets are for preheat flames of oxygen and acetylene. The central jet carries only oxygen for cutting.
A thermal lance, thermic lance, oxygen lance, or burning bar is a tool that heats and melts steel in the presence of pressurized oxygen to create very high temperatures for cutting. It consists of a long steel tube packed with alloy steel rods, which serve as fuel; these are sometimes mixed with aluminum rods to increase the heat output.
A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.
2 Cutting / welding. 6 comments Toggle Cutting / welding subsection. 2.1 Shut off oxygen first or acetylene first? 3 Instructional content. 9 comments. 4 RfM. 1 ...
Depending on the application they are also often used at the torch side as an additional safety device. Flashback arrestors help prevent: Further gas flow in the case of pressure shocks. The entry of air or oxygen into the distribution line or single cylinders. Flashbacks which are the rapid propagation of a flame down the hose.
Oxyhydrogen is a mixture of hydrogen (H 2) and oxygen (O 2) gases. This gaseous mixture is used for torches to process refractory materials and was the first [1] gaseous mixture used for welding. Theoretically, a ratio of 2:1 hydrogen:oxygen is enough to achieve maximum efficiency; in practice a ratio 4:1 or 5:1 is needed to avoid an oxidizing ...