Ad
related to: oil cooler leak cts-v engine swap chevy s 10
Search results
Results From The WOW.Com Content Network
For 1986, Chevrolet changed over to a one-piece rear main seal engine block design to minimize leaks and warranty claims; however, some early 1986 blocks retained a two-piece rear main seal. For 1987, Chevrolet once again made some revisions to increase overall reliability, many of them borrowed from the TBI L03 , which was to replace the LG4.
Work Completed: Pushrod tube seals and gasket replaced to fix oil leaks, engine cleaned and powder coated, interior overhauled, convertible soft top replaced, brightwork replaced, new wheels and tyres installed, full respray from white to Seafoam Green, suspension bushes and ball joints replaced, springs and shocks replaced, compensator bar ...
The LLT engine has a compression ratio of 11.3:1, and has been certified by the SAE to produce 302 hp (225 kW; 306 PS) at 6300 rpm and 272 lb⋅ft (369 N⋅m) of torque at 5200 rpm on regular unleaded (87 octane) gasoline. This engine debuted on the 2008 Cadillac STS and CTS.
The Cadillac CTS is a luxury car, manufactured and marketed by General Motors from 2003 until 2019 across three generations.. Initially available as a 4-door sedan using the GM Sigma platform, GM offered the second generation CTS in 4-door sedan, 2-door coupe, and 5-door sport wagon, and the third generation as a sedan, using a stretched version of the GM Alpha platform.
This engine was similar to the LQ5, except that it used a two-barrel carburetor instead of a throttle-body fuel injection system. This engine was used in the Chevrolet S-10 and GMC S-15 compact pickup trucks and their Blazer and Jimmy counterparts until 1985, when it was replaced by the 2.5-liter Tech IV engine. This engine produced 83 hp (62 ...
In car tuning culture, an engine swap is the process of removing a car's original engine and replacing it with another. This may be a like-for-like replacement, or to install a non-factory specification engine.
Oil cooling is the use of engine oil as a coolant, typically to remove surplus heat from an internal combustion engine. The hot engine transfers heat to the oil which then usually passes through a heat-exchanger, typically a type of radiator known as an oil cooler. The cooled oil flows back into the hot object to cool it continuously.
The fuel injection was a batch fire system and used a two piece cast aluminum dual-plenum manifold. This engine was available in Chevrolet S-10/GMC Sonoma pickups, Chevrolet S-10 Blazer/GMC S-15 Jimmy/Oldsmobile Bravada SUVs, and Chevrolet Astro/GMC Safari vans only. The L35 was rated at 200 hp (149 kW) and 260 lb⋅ft (353 N⋅m) of torque.