Search results
Results From The WOW.Com Content Network
The commonly used standard cell has a width of 1 cm [clarify], and thus for very pure water in equilibrium with air would have a resistance of about 10 6 ohms, known as a megohm. Ultra-pure water could achieve 18 megohms or more. Thus in the past, megohm-cm was used, sometimes abbreviated to "megohm".
The siemens (symbol: S) is the unit of electric conductance, electric susceptance, and electric admittance in the International System of Units (SI). Conductance, susceptance, and admittance are the reciprocals of resistance, reactance, and impedance respectively; hence one siemens is equal to the reciprocal of one ohm (Ω −1) and is also referred to as the mho.
where is the length of the conductor, measured in metres (m), A is the cross-sectional area of the conductor measured in square metres (m 2), σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω ...
If this convention is used, then the values are in the same range as monovalent ions, e.g. 59.5 S cm 2 mol −1 for 1 / 2 Ca 2+ and 80.0 S cm 2 mol −1 for 1 / 2 SO 2− 4. [4] From the ionic molar conductivities of cations and anions, effective ionic radii can be calculated using the concept of Stokes radius.
The resistivity can be expressed using the SI unit ohm metre (Ω⋅m) — i.e. ohms multiplied by square metres (for the cross-sectional area) then divided by metres (for the length). Both resistance and resistivity describe how difficult it is to make electrical current flow through a material, but unlike resistance, resistivity is an ...
Admittance Y, measured in siemens, is defined as the inverse of impedance Z, measured in ohms: Y ≡ 1 Z {\displaystyle Y\equiv {\frac {1}{Z}}} Resistance is a measure of the opposition of a circuit to the flow of a steady current, while impedance takes into account not only the resistance but also dynamic effects (known as reactance ).
For a typical current of 10 mA, g m ≈ 385 mS. The input impedance is the current gain ( β ) divided by the transconductance. The output (collector) conductance is determined by the Early voltage and is proportional to the collector current.
As quoted in an online version of: David R. Lide (ed), CRC Handbook of Chemistry and Physics, 84th Edition.CRC Press. Boca Raton, Florida, 2003; Section 4, Properties of the Elements and Inorganic Compounds; Physical Properties of the Rare Earth Metals