Ads
related to: what is ball valve in irrigation system design
Search results
Results From The WOW.Com Content Network
A ball valve is a flow control device which uses a hollow, perforated, and pivoting ball to control fluid flowing through it. It is open when the hole through the middle of the ball is in line with the flow inlet, and closed when it is pivoted 90 degrees by the valve handle, blocking the flow. [1]
Schematic 3 way ball valve: L-shaped ball right, T-shaped left. Valves with three ports serve many different functions. A few of the possibilities are listed here. Three-way ball valves come with T- or L-shaped fluid passageways inside the rotor. The T valve might be used to permit connection of one inlet to either or both outlets or connection ...
As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.
Valve actuator – which moves the valve's modulating element, such as ball or butterfly. Valve positioner – which ensures the valve has reached the desired degree of opening. This overcomes the problems of friction and wear. Valve body – in which the modulating element, a plug, globe, ball or butterfly, is contained.
Most automatic irrigation valves are diaphragm valves in which the water above the diaphragm must be discharged for the valve to open. In a hydraulic system, the controller and valves are connected via small plastic tubes approximately 4 mm (¼ in) in diameter. The controller opens the tube connected to the valve, allowing that valve to open ...
Larner–Johnson Valve: needle control valve often in large sizes used in water supply systems; Leaf valve: one-way valve consisting of a diagonal obstruction with an opening covered by a hinged flap; Line blind valve: a thin sheet oriented perpendicular to the pipe. The sheet has a solid end and a flow-through end; sliding it from one position ...
Control valves are normally fitted with actuators and positioners. Pneumatically-actuated globe valves and diaphragm valves are widely used for control purposes in many industries, although quarter-turn types such as (modified) ball and butterfly valves are also used. Control valves can also work with hydraulic actuators (also known as ...
An isolation valve is a valve in a fluid handling system that stops the flow of process media to a given location, usually for maintenance or safety purposes. [1] They can also be used to provide flow logic (selecting one flow path versus another), and to connect external equipment to a system. [ 2 ]