When.com Web Search

  1. Ads

    related to: charging trolling battery from outboard

Search results

  1. Results From The WOW.Com Content Network
  2. Trolling motor - Wikipedia

    en.wikipedia.org/wiki/Trolling_motor

    A trolling motor is a self-contained marine propulsion unit that includes an electric motor, propeller and control system, and is affixed to an angler's boat, either at the bow or stern. A gasoline-powered outboard used in trolling , if it is not the vessel's primary source of propulsion, may also be referred to as a trolling motor.

  3. Electric boat - Wikipedia

    en.wikipedia.org/wiki/Electric_boat

    An electric boat is a powered watercraft driven by electric motors, which are powered by either on-board battery packs, solar panels or generators. [ 1 ] While a significant majority of water vessels are powered by diesel engines , with sail power and gasoline engines also popular, boats powered by electricity have been used for over 120 years.

  4. Deep-cycle battery - Wikipedia

    en.wikipedia.org/wiki/Deep-cycle_battery

    A deep-cycle battery powering a traffic signal. A deep-cycle battery is a battery designed to be regularly deeply discharged using most of its capacity. The term is traditionally mainly used for lead–acid batteries in the same form factor as automotive batteries; and contrasted with starter or cranking automotive batteries designed to deliver only a small part of their capacity in a short ...

  5. Outboard motor - Wikipedia

    en.wikipedia.org/wiki/Outboard_motor

    The first known outboard motor was a small 11 pound (5 kg) electric unit designed around 1870 by Gustave Trouvé, [9] and patented in May 1880 (Patent N° 136,560). [10] Later about 25 petrol powered outboards may have been produced in 1896 by American Motors Co [9] —but neither of these two pioneering efforts appear to have had much impact.

  6. Trickle charging - Wikipedia

    en.wikipedia.org/wiki/Trickle_charging

    Trickle charging is the process of charging a fully charged battery at a rate equal to its self-discharge rate, enabling the battery to remain at its fully charged level. This state occurs almost exclusively when the battery is not loaded, as trickle charging will not keep a battery charged if current is being drawn by a load.

  7. Capacitor discharge ignition - Wikipedia

    en.wikipedia.org/wiki/Capacitor_discharge_ignition

    First, the system voltage is raised to 250 to 600 volts by a power supply inside the CDI module. Then, the electric current flows to the charging circuit and charges the capacitor. The rectifier inside the charging circuit prevents capacitor discharge before the moment of ignition. When the triggering circuit receives the triggering signal, the ...