Ads
related to: function of breather in transformer switch for dryer
Search results
Results From The WOW.Com Content Network
A discrete breather is a breather solution on a nonlinear lattice. The term breather originates from the characteristic that most breathers are localized in space and oscillate in time. [1] But also the opposite situation: oscillations in space and localized in time [clarification needed], is denoted as a breather.
No-load tap changer (NLTC), also known as Off-circuit tap changer (OCTC) or De-energized tap changer (DETC), is a tap changer utilized in situations in which a transformer's turn ratio does not require frequent changing and it is permissible to de-energize the transformer system. This type of transformer is frequently employed in low power- low ...
Arcing horns protecting bushings on a distribution transformer. Arcing horns form a spark gap across the insulator with a lower breakdown voltage than the air path along the insulator surface, so an overvoltage will cause the air to break down and the arc to form between the arcing horns, diverting it away from the surface of the insulator. [3]
A breather switch, expansion joint, or adjustment switch is an intentional gap in railway tracks to allow for thermal expansion in long sections of otherwise unbroken rail. . They are placed between very long sections of continuous welded rail or at the transition from continuous welded rail to jointed track, and commonly in the vicinity of bridges, viaducts and tunnels where the ...
In electrical engineering, a transformer is a passive component that transfers electrical energy from one electrical circuit to another circuit, or multiple circuits.A varying current in any coil of the transformer produces a varying magnetic flux in the transformer's core, which induces a varying electromotive force (EMF) across any other coils wound around the same core.
A "transformer bank", widely used in North America: three single-phase transformers connected to make a 3-phase transformer. The low-voltage secondary windings are attached to three or four terminals on the transformer's side. In North American residences and small businesses, the secondary is often the split-phase 120/240-volt system. The 240 ...
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
This switch is gang-operated so that all three phases are interrupted at the same time. Knife switches consist of a flat metal blade, hinged at one end, with an insulating handle for operation, and a fixed contact. When the switch is closed, current flows through the hinged pivot and blade and through the fixed contact.