Search results
Results From The WOW.Com Content Network
Another method of reducing the fan speed [5] is by moving the 5 V wire in the classical Molex power connector in the place of the Ground wire going to the fan, thereby delivering +7 V (12 V − 5 V = 7 V) to the fan. However, this is a potentially risky method, because +5 V PSU line is intended to source current only, not sink it, so the PSU is ...
SpeedFan is a system monitor for Microsoft Windows that can read temperatures, voltages and fan speeds of computer components. [3] It can change computer fan speeds depending on the temperature of various components. [1] [4] The program can display system variables as charts and as an indicator in the system tray.
Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow. Fan noise has been found to be roughly proportional to the fifth power of fan speed; halving the speed reduces the noise by about 15 dB. [22] Axial fans may rotate at speeds of up to around 38,000 rpm for smaller sizes. [23]
Step #3: Add more RAM to your hardware. RAM is a temporary memory used by your computer's operating system and helps your programs run smoothly.
Remove clutter from your computer and recover valuable disk space to make your computer as efficient as possible, all while protecting your privacy.
A finned air cooled heatsink with fan clipped onto a CPU, with a smaller passive heatsink without fan in the background A 3-fan heatsink mounted on a video card to maximize cooling efficiency of the GPU and surrounding components Commodore 128DCR computer's switch-mode power supply, with a user-installed 60 mm cooling fan. Vertical aluminium ...
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
The +12 V supply was used for computer fan motors, disk drive motors and serial interfaces (which also used the −12 V supply). A further use of the 12 V came with the sound cards, using linear chip audio power amplifiers , sometimes filtered by a 9 V linear regulator on the card to cut the noise of the motors.