Search results
Results From The WOW.Com Content Network
The motor constant is winding independent (as long as the same conductive material is used for wires); e.g., winding a motor with 6 turns with 2 parallel wires instead of 12 turns single wire will double the velocity constant, , but remains unchanged.
Thus it is not possible to control the motor if the output frequency of the variable frequency drive is zero. However, by careful design of the control system it is possible to have the minimum frequency in the range 0.5 Hz to 1 Hz that is enough to make possible to start an induction motor with full torque from a standstill situation. A ...
The switched reluctance motor (SRM) is a type of reluctance motor. Unlike brushed DC motors , power is delivered to windings in the stator (case) rather than the rotor . This simplifies mechanical design because power does not have to be delivered to the moving rotor, which eliminates the need for a commutator .
IQ data has extensive use in many signal processing contexts, including for radio modulation, software-defined radio, audio signal processing and electrical engineering. I/Q data is a two-dimensional stream. Some sources treat I/Q as a complex number; [1] with the I and Q
The graphs below show the angle domain equations for a constant rod length (6.0") and various values of half stroke (1.8", 2.0", 2.2"). Note in the graphs that L is rod length l {\displaystyle l} and R is half stroke r {\displaystyle r} .
The torsion constant or torsion coefficient is a geometrical property of a bar's cross-section. It is involved in the relationship between angle of twist and applied torque along the axis of the bar, for a homogeneous linear elastic bar. The torsion constant, together with material properties and length, describes a bar's torsional stiffness.
Free-body diagram of a U-channel synchronous linear motor. The view is perpendicular to the channel axis. The two coils at centre are mechanically connected, and are energized in "quadrature" (meaning a phase difference of 90° (π/2 radians) between the flux of the magnets and the flux of the coils). The bottom and upper coils in this ...
The equation governing the rotor motion is given by: [1] = =, where: J {\displaystyle J} is the total moment of inertia of the rotor mass in kg-m 2 θ m {\displaystyle \theta _{\text{m}}} is the angular position of the rotor with respect to a stationary axis in radians (rad)