Ads
related to: ridge beam and rafter system for construction companytimberlyne.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam , which has extra bracing to attach it to the rafters. The purlins are the large beams perpendicular to the rafters; from this shot, it appears that there are three purlins on either side of the roof.
The foot of a hip rafter lands on a dragon beam. King rafter: the longest rafter on the side of a hip roof in line with the ridge. Valley rafter (historically also called a sleeper): A rafter forming a valley (look for illustration showing a valley). Intermediate rafter: "one between principal or common rafters to strengthen a given place" (rare).
The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple. Depending on the roof covering material, either horizontal laths , battens , or purlins are fixed to the rafters; or boards, plywood , or oriented strand board form the roof deck (also called the sheeting or ...
A single, central post in a roof truss in tension between the rafters and a tie beam (bottom chord), or 2) (U.S.) A short of the tie beam only supporting the rafters via struts. 3) (U.K.) A king post specifically carries a ridge beam otherwise is called a king strut. "King post" was formerly used to describe a crown post in the U. K., but no ...
The jetty beams or joists conform t floor dimensions above, but are at right angles to the jetty-plates that conform to the shorter dimensions of "roof" of the floor below. Jetty beams are mortised at 45° into the sides of the dragon beams. They are the main constituents of the cantilever system, and determine how far the jetty projects.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
The German term for this construction is Firstständerhaus. The free-standing posts in the interior of the house and the posts in the gable or lateral walls were originally called Firstsäule ("ridge columns"). On a purlin roof the ridge posts carry the ridge purlin. On the latter are hung the sloping rafters to which the roof is fixed.