Search results
Results From The WOW.Com Content Network
Fault (geology) Satellite image of a fault in the Taklamakan Desert. The two colorful ridges (at bottom left and top right) used to form a single continuous line, but have been split apart by movement along the fault. In geology, a fault is a planar fracture or discontinuity in a volume of rock across which there has been significant ...
A thrust fault is a type of reverse fault, in which the rock above the fault is displaced upwards relative to the rock below the fault. This distinguishes reverse faults from normal faults, where the rock above the fault is displaced downwards, or strike-slip faults, where the rock on one side of the fault is displaced horizontally with respect ...
A thrust fault is a type of reverse fault that has a dip of 45 degrees or less. [1][2] If the angle of the fault plane is lower (often less than 15 degrees from the horizontal [3]) and the displacement of the overlying block is large (often in the kilometer range) the fault is called an overthrust or overthrust fault. [4]
Anderson's theory of faulting. Anderson's theory of faulting, devised by Ernest Masson Anderson in 1905, is a way of classifying geological faults by use of principal stress. [1][2] A fault is a fracture in the surface of the Earth that occurs when rocks break under extreme stress. [3] Movement of rock along the fracture occurs in faults.
Transform fault. A transform fault or transform boundary, is a fault along a plate boundary where the motion is predominantly horizontal. [1] It ends abruptly where it connects to another plate boundary, either another transform, a spreading ridge, or a subduction zone. [2] A transform fault is a special case of a strike-slip fault that also ...
A triple junction is the point where the boundaries of three tectonic plates meet. At the triple junction each of the three boundaries will be one of three types – a ridge (R), trench (T) or transform fault (F) – and triple junctions can be described according to the types of plate margin that meet at them (e.g. Fault-Fault-Trench, Ridge ...
Relative plate motion can be lateral as along a transform fault boundary, vertical if along a convergent boundary (i.e. subduction or thrust/reverse faulting) or a divergent boundary (i.e. rift zone or normal faulting), and oblique, with horizontal and lateral components at the boundary.
Tilted block faulting, also called rotational block faulting, is a mode of structural evolution in extensional tectonic events, a result of tectonic plates stretching apart. [1][2] When the upper lithospheric crust experiences extensional pressures, the brittle crust fractures, creating detachment faults. [3]