When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

3. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   An automatic center punch is a hand tool used to produce a dimple in a workpiece (for example, a piece of metal). It performs the same function as an ordinary center punch but without the need for a hammer. When pressed against the workpiece, it stores energy in a spring, eventually releasing it as an impulse that drives the punch, producing ...

4. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.

5. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   A spade drill bit for metal is a two part bit with a tool holder and an insertable tip, called an insert. The inserts come in various sizes that range from 7 ⁄ 16 to 2.5 inches (11 to 64 mm). The tool holder usually has a coolant passage running through it. [13] They are capable of cutting to a depth of about 10 times the bit diameter.

7. Machine tool - Wikipedia

   en.wikipedia.org/wiki/Machine_tool

   Matter-Additive, Matter-Preserving, and Matter-Subtractive "Manufacturing" can proceed in sixteen ways: Firstly, the work may be held either in a hand, or a clamp; secondly, the tool may be held either in a hand, or a clamp; thirdly, the energy can come from either the hand(s) holding the tool and/or the work, or from some external source ...