Ads
related to: magnetic proximity switch alarm controller for car system
Search results
Results From The WOW.Com Content Network
Electromagnetic sensors rely on the vehicle moving slowly and smoothly towards the object to be avoided. Once an obstacle is detected, the sensor continues to signal the presence of the obstacle even if the vehicle momentarily stops. If the vehicle then resumes moving backwards the alarm signal becomes louder as the obstacle is approached.
The reed switch [i] is an electromechanical switch operated by an applied magnetic field. It was invented in 1922 by professor Valentin Kovalenkov at the Petrograd Electrotechnical University , [ 1 ] and later evolved at Bell Telephone Laboratories in 1936 by Walter B. Ellwood into the reed relay.
Reed Switch. The hermetically sealed reed switch is a common type of two-piece sensor. This switch operates with an electrically conductive switch that is either normally open or normally closed when under the influence of a magnetic field in respect to proximity to the second piece, which contains a magnet.
An induction or inductive loop is an electromagnetic communication or detection system which uses a moving magnet or an alternating current to induce an electric current in a nearby wire. Induction loops are used for transmission and reception of communication signals, or for detection of metal objects in metal detectors or vehicle presence ...
Atomic Gravitational Wave Interferometric Sensor; Attitude control (spacecraft): Horizon sensor, Earth sensor, Moon sensor, Satellite Sensor, Sun sensor; Catadioptric sensor; Chemoreceptor; Compressive sensing; Cryogenic particle detectors; Dew warning; Diffusion tensor imaging; Digital holography; Electronic tongue; Fine Guidance Sensor; Flat ...
Alarms often come with a mix of features. Remote car alarms typically consist of an additional radio receiver that allows the owner to wirelessly control the alarm from a key fob. Remote car alarms typically come equipped with an array of sensors along with immobilizers and motion detectors. [citation needed]
An alarm is used to warn the driver of a potential collision hazard in the pre-collision system. The pre-collision braking control was upgraded in 2010 to allow the vehicle to stop automatically if the speed difference between the EyeSight-equipped vehicle and the object in front is less than 30 km/h (19 mph) and the driver takes no action to ...
A VR sensor used as a simple proximity sensor can determine the position of a mechanical link in a piece of industrial equipment. A crankshaft position sensor (in an automobile engine) is used to provide the angular position of the crankshaft to the engine control unit. The engine control unit can then calculate engine speed (angular velocity).