Ads
related to: splicing anchor rope to chain link gate hinge bolt
Search results
Results From The WOW.Com Content Network
Shaped in the form of a narrow metal cone tapered to a rounded or flattened point, it is used in tasks such as unlaying rope for splicing, untying knots, drawing tight using a marlinspike hitch, and as a toggle joining ropes under tension in a belaying pin splice.
In addition to holding rope open to assist the creation of a rope splice, modern push fids have markings for precise measurements in a variety of sizes of rope. The length of these fids is typically 21 or 22 times the diameter of rope to be spliced. A one-half-inch (12.7 mm) diameter rope would have any accompanying fid 10.5–11 in (266.7 ...
Chain splice – Attached the working end of a rope to a chain. [7] Figure-eight "splice" knot – A splice-like bend knot used for joining two ropes. Horseshoe splice – A cut splice where the two sides of the loop are of unequal length. Long splice – A splice used to join two rope ends forming one rope the length of the total of the two ropes.
Rope – Length of braided strands; Shackle – Metal assembly which functions as a removable connecting link; Sheave – Grooved wheel used to support a moving belt, wire or rope; Sheer legs; Sling (rigging) – Rope, webbing, wire or chain used to support a load for lifting; Rope splicing – Semi-permanent joint between two ropes
Fang bolts or rail anchor bolts have also been used for fixing rails or chairs to sleepers. The fang bolt is a bolt inserted through a hole in the sleeper with a fanged nut that bites into the lower surface of the sleeper. For fastening flat-bottomed rails, an upper-lipped washer can be used to grip the edge of the rail.
A bight is a slack part in the middle of a rope, usually a curve or loop. [1] [2] Knots that can be tied without access to either end of the rope are called knots in the bight. To tie a knot with a bight is to double up the rope into a bight and then tie the knot using the double rope.