Ads
related to: hilti epoxy anchors hole size guide
Search results
Results From The WOW.Com Content Network
Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.
Bonded anchors are also referred as adhesive anchors [9] or chemical anchors. The anchoring material is an adhesive (also called mortar) [3] usually consisting of epoxy, polyester, or vinylester resins. [1] In bonded anchors, the force-transfer mechanism is based on bond stresses provided by binding organic materials.
In 1941, the Hilti company Maschinenbau Hilti OHG was founded by Martin (1915–1997) and Eugen Hilti (1911–1964), [3] with the opening of a mechanical workshop in Schaan, Liechtenstein. Martin Hilti was trained in mechanical engineering and automotive design at the Wismar Engineering College and was 26 at the time of founding the company.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.
Even though #14 and #16 screws are still available, they are not as common as sizes #0 through #12. [citation needed] Sometimes "special" diameter and pitch combinations (UNS) are used, for example a 0.619 in (15.7 mm) major diameter with 20 threads per inch. UNS threads are rarely used for bolts, but rather on nuts, tapped holes, and threaded ODs.
Ad
related to: hilti epoxy anchors hole size guide