Search results
Results From The WOW.Com Content Network
A ferrite loopstick antenna, a small loop used for AM reception in a portable radio, consisting of a wire wound around a ferrite core; the most common type of loop antenna today. A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor , that for transmitting is usually fed by a balanced ...
It usually consists of a single wire or network of horizontal wires, parallel to the ground, suspended above the ground under the antenna, connected to the receiver or transmitter's "ground" wire. [2] The counterpoise functions as one plate of a large capacitor, with the conductive layers of the earth acting as the other plate. [2] [3]
The category of simple antennas consists of dipoles, monopoles, and loop antennas. Nearly all can be made with a single segment of wire (ignoring the break made in the wire for the feedline connection).
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The loop acts like a short circuited single-turn transformer winding; any AC magnetic flux from nearby transformers, electric motors, or just adjacent power wiring, will induce AC currents in the loop by induction. In general, the larger the area spanned by the loop and the larger the magnetic flux through it, the larger the induced currents ...
Isolation transformer. In classical transformers, there are two electrically separate windings of wire coils around the transformer's core. The advantage of transformer-type over other types of balun is that the electrically separate windings for input and output allow these baluns to connect circuits whose ground-level voltages are subject to ground loops or are otherwise electrically ...
Indoor antennas are designed to be located on top of or next to the television set, but are ideally placed near a window in a room and as high up as possible for the best reception. [1] The most common types of indoor antennas are the dipole [2] ("rabbit ears"), which work best for VHF channels, and loop antennas, which work best for UHF. [3]
AS 1103.2-1982 - "Diagrams charts and tables for electrotechnology, Part 2: Item Designation" (Superseded by AS 3702-1989.) AS 3702-1989 - "Item designation in electrotechnology". (Equivalent to IEC 60750 Edition 1.0, 1983.) IEC 113 (Superseded by IEC 750, i.e. IEC 60750.) IEC 750-1983 (AS 3702 is equivalent, but provides extra information.)