When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   JST manufactures numerous series (families) and pitches (pin-to-pin distance) of connectors. [ 2 ] [ 3 ] JST connectors are used in many types of products, and commonly used by electronics hobbyists and consumer products for rechargeable battery packs, battery balancers , battery eliminator circuits , 3D printers , and radio controlled servos .

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.

5. IEC 60320 - Wikipedia

   en.wikipedia.org/wiki/IEC_60320

   A variety of different kinds of IEC 60320 plugs and sockets. IEC 60320 Appliance couplers for household and similar general purposes [1] is a set of standards from the International Electrotechnical Commission (IEC) specifying non-locking connectors for connecting power supply cords to electrical appliances of voltage not exceeding 250 V (a.c.) and rated current not exceeding 16 A. [1 ...

6. Pin header - Wikipedia

   en.wikipedia.org/wiki/Pin_header

   1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.

7. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.