Search results
Results From The WOW.Com Content Network
The screw thread sizes and "genders" used for attaching brushes to the rods vary between different calibers and manufacturers. Some of the most common threads and genders for rods/cords are listed below. [1] Corresponding brushes and other accessories will have the opposite gender. Rods for .17 to .204 caliber (4.4 to 5.2 mm) #5-40 UNC female
Note: Use of this table for estimating bullet masses for historical large-bore rifles is limited, as this table assumes the use of round ball, rather than conical bullets; for example, a typical 4-bore rifle from circa 1880 used a 2,000-grain (4.57 oz; 129.60 g) bullet, or sometimes slightly heavier, rather than using a 4-ounce (110 g) round ...
List of rifle cartridges, by primer type, calibre and name. ... .410 bore — .410 in (10.4 mm) 32 gauge — .526 in (13.4 mm) 28 gauge — .550 in (14.0 mm)
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
Common rifle cartridges, from the largest .50 BMG to the smallest .22 Long Rifle with a $1 United States dollar bill in the background as a reference point.. This is a table of selected pistol/submachine gun and rifle/machine gun cartridges by common name.
The name, derived from an old English practice of bore measurements in gun-making which refers to a nominally 4-gauge bore, that is, a bore diameter that would accommodate a pure lead round ball weighing 1 ⁄ 4 of a pound. This would imply a bore diameter of 1.052-inch (26.7 mm), however in practice the bore diameter varied greatly as, in ...
Rifleman's rule is a "rule of thumb" that allows a rifleman to accurately fire a rifle that has been calibrated for horizontal targets at uphill or downhill targets. The rule says that only the horizontal range should be considered when adjusting a sight or performing hold-over in order to account for bullet drop.
The .450 Bushmaster is descended from the Thumper concept popularized by the gun writer Jeff Cooper.Cooper was dissatisfied with the small-diameter 5.56×45mm NATO (.223 Remington) of the AR-15, and envisioned a need for a large bore (.44 cal or greater) cartridge in a semi-automatic rifle to provide one-shot kills on big-game animals at 250 yards.