When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   Wheel hub with disc brake and 5 wheel studs. Wheel studs are the threaded fasteners that hold on the wheels of many automobiles. They are semi-permanently mounted directly to the vehicle hub, usually through the brake drum or brake disk. Lug nuts are fastened onto the wheel stud to secure the wheel. When a wheel is removed for tire changes etc ...

3. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The bolt pattern determines the number and position of the bolt holes on the wheel to line up with your vehicle's studs on the mounting hubs. The bolt holes are spaced evenly about the bolt hole circle. Wheel studs are the bolts that are on your mounting hub and are used along with lug nuts to attach the wheel to the car. The bolt hole circle ...

4. Lug nut - Wikipedia

   en.wikipedia.org/wiki/Lug_nut

   From left: 9 lug nuts and 4 lug nut attached to screw-in wheel studs. A bolt circle with four lug nuts on an Acura. A lug nut or wheel nut is a fastener, specifically a nut, used to secure a wheel on a vehicle. Typically, lug nuts are found on automobiles, trucks (lorries), and other large vehicles using rubber tires.

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.

6. List of bicycle parts - Wikipedia

   en.wikipedia.org/wiki/List_of_bicycle_parts

   Common over crank bolts, often plastic; Dynamo: bicycle lighting component, also known as generator; Eyelet: 1) attachment point on frame, fork, or dropout for fenders, racks, etc. 2) a hole through which a spoke nipple passes through the rim so it may attach to a spoke

7. Threaded rod - Wikipedia

   en.wikipedia.org/wiki/Threaded_rod

   Tap-end studs have threads at extreme ends of the body with unequal thread engagement length, while double-end stud bolts have equal thread length at both ends. Apart from these, there are stud bolts for flanges, which are fully threaded studs with chamfered ends, and double-end studs with reduced shank for special bolting applications. For ...