Ads
related to: hyundai p0720 code for 4 speed engine module sensor
Search results
Results From The WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The Ford EEC (Electronic Engine Control) system, which utilized the Toshiba TLCS-12 microprocessor, went into mass production in 1975. [ 7 ] The first Bosch engine management system was the Motronic 1.0 , which was introduced in the 1979 BMW 7 Series (E23) [ 8 ] This system was based on the existing Bosch Jetronic fuel injection system, to ...
Hyundai Motor Company has produced the following families of automobile engines. Gasoline engines use a naming system based on Greek letters. Spark Ignition (Gasoline) Straight-3. Epsilon ε - 0.8 L; Kappa κ - 1.0 L; Straight-4. Epsilon ε - 1.0/1.1 L; Kappa κ - 1.2/1.25/1.4/1.6 L; Alpha α - 1.3/1.4/1.5/1.6 L; Gamma γ - 1.4/1.6 L; Sirius ...
The 2.4L version is an inline 4-cylinder engine that carries a bore of 88.0 mm, stroke of 97.0 mm and a 10.5:1 compression ratio; the engine dry weight is 146 kg (322 lb) and it makes 165 PS (121 kW; 163 hp) at 5,800 rpm and 22.3–23 kg⋅m (161–166 lb⋅ft; 219–226 N⋅m) of torque at 4,250 rpm.
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
An electronic control unit (ECU), also known as an electronic control module (ECM), is an embedded system in automotive electronics that controls one or more of the electrical systems or subsystems in a car or other motor vehicle.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]