Search results
Results From The WOW.Com Content Network
The input offset voltage is a parameter defining the differential DC voltage required between the inputs of an amplifier, especially an operational amplifier (op-amp), to make the output zero (for voltage amplifiers, 0 volts with respect to ground or between differential outputs, depending on the output type).
Referring to the above diagram, if the op-amp is assumed to be ideal, then the voltage at the inverting (-) input is held equal to the voltage at the non-inverting (+) input as a virtual ground. The input voltage passes a current V in / R 1 {\displaystyle V_{\text{in}}/{R_{1}}} through the resistor producing a compensating current flow through ...
Slewing is associated with the large-signal performance of an op amp. Consider, for example, an op amp configured for a gain of 10. Let the input be a 1 V, 100 kHz sawtooth wave. That is, the amplitude is 1 V and the period is 10 microseconds. Accordingly, the rate of change (i.e., the slope) of the input is 0.1 V per microsecond.
The current-feedback operational amplifier (CFOA or CFA) is a type of electronic amplifier whose inverting input is sensitive to current, rather than to voltage as in a conventional voltage-feedback operational amplifier (VFA). The CFA was invented by David Nelson at Comlinear Corporation, and first sold in 1982 as a hybrid amplifier, the CLC103.
The operational transconductance amplifier (OTA) is an amplifier that outputs a current proportional to its input voltage. Thus, it is a voltage controlled current source . Three types of OTAs are single-input single-output, differential-input single-output, and differential-input differential-output (a.k.a. fully differential), [ 1 ] however ...
A circuit diagram of a inverting amplifier made using an operational amplifier. = ...
A differential amplifier is a type of electronic amplifier that amplifies the difference between two input voltages but suppresses any voltage common to the two inputs. [1] It is an analog circuit with two inputs and + and one output , in which the output is ideally proportional to the difference between the two voltages:
Schematic symbol for an OTA has inverting (V in-) and noninverting (V in+) inputs, power supply lines (V + and V −), two biasing inputs (I abc and I bias), and a single output current I out. The LM13700 is an integrated circuit (IC) containing two current -controlled operational transconductance amplifiers (OTA), each having differential ...