Search results
Results From The WOW.Com Content Network
A strut bar, strut brace, or strut tower brace (STB) is an automotive suspension accessory on a monocoque or unibody chassis to provide extra stiffness between the strut towers. With a MacPherson strut suspension system where the spring and shock absorber combine in one suspension unit, which also replaces the upper control arm, the entire ...
The lower tie bar is mostly an aftermarket car component. Some of the few exceptions to this rule are the Honda Integra and Civic Type-R, as well as the Daihatsu Charade GTti. Since the lower tie bar is one of the cheapest upgrade that tuners can install on their cars, it is probably one of the first performance accessories is acquired. The ...
The damper and spring are assembled as a unit prior to installation, and are replaced as a unit when either of the sub-components fails. Some coilovers are adjustable. Most, if not all, adjustable coilovers have variable ride height and preload , adjusted using a simple threaded spring perch similar to a nut .
Anti-roll bar (in red) attached to a front axle. The bar must also have its two longitudinal anchor points fastened solidly to transfer forces from side to side. An anti-sway or anti-roll bar is intended to reduce the lateral tilt (roll) of the vehicle on curves, sharp corners, or large bumps.
The coil springs usually bear on a pad alongside the stub-axle. Often, the shock is collinear with the spring forming a coil-over. In many cases, the damper is also used as a restraint strap to stop the arm descending so far that the coil spring falls out through being completely unloaded.
One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever, the torsion key, mounted perpendicular to the bar, that is attached to a suspension arm, a spindle, or the axle. Vertical motion of the wheel causes the bar to twist around its axis and is resisted by the bar's torsion resistance. The ...
Strut is normally made of sheet steel, with a zinc coating (), paint, epoxy, powder coat, or other finish.. Strut channel is also manufactured from stainless steel for use where rusting might become a problem (e.g., outdoors, facilities with corrosive materials), from aluminium alloy when weight is an issue or from fiberglass for very corrosive environments.
The strut will usually carry both the coil spring, on which the body is suspended, and the shock absorber, which is usually in the form of a cartridge mounted within the strut (see coilover). The strut can also have the steering arm built into the lower outer portion. The whole assembly is very simple and can be pre-assembled into a unit.