Ads
related to: difference between se and b3 tires on cars diagram
Search results
Results From The WOW.Com Content Network
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
Differences between trim levels typically consist of interior equipment (e.g., leather seats and reversing cameras) and cosmetic changes; [2] [3] however, a trim level can sometimes include mechanical changes such as different engines, suspension, or all-wheel-drive systems.
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
The Toyota Land Cruiser (J40), is a series of Land Cruisers made by Toyota from 1960 until 2001. The 40 series Land Cruisers featured a traditional body on frame construction, and most were built as 2-door models with slightly larger dimensions than the similar Jeep CJ.
The first generations were known as B1, B2, B3, B4, B5, from 1977 until 1981, and the second and last generation was known as the B2 and B3 from 1986 until 1988. The later models were made after GM released the kits and parts to Iran following the GM's debt to Iran General Motors.
For road vehicles with more than two axles (e.g. some trucks), the wheelbase is the distance between the steering (front) axle and the centerpoint of the driving axle group. In the case of a tri-axle truck, the wheelbase would be the distance between the steering axle and a point midway between the two rear axles. [1]
In October 2010, the Passat Alltrack debuted at the 2010 Tokyo Motor Show, bridges the gap between Volkswagen passenger car and SUV ranges. The Passat Alltrack has raised ground clearance from 135 to 165 mm which improves approach angle from 13.5 to 16 degrees, departure angle from 11.9 to 13.6 degrees and ramp angle from 9.5 to 12.8 degrees ...
When a wheel is set up to have some camber angle, the interaction between the tire and road surface causes the wheel to tend to want to roll in a curve, as if it were part of a conical surface (camber thrust). This tendency to turn increases the rolling resistance as well as increasing tire wear. A small degree of toe (toe-out for negative ...