Ads
related to: solving circuits with diodes
Search results
Results From The WOW.Com Content Network
The real diode now can be replaced with the combined ideal diode, voltage source and resistor and the circuit then is modelled using just linear elements. If the sloped-line segment is tangent to the real diode curve at the Q-point, this approximate circuit has the same small-signal circuit at the Q-point as the real diode.
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
Shockley derives an equation for the voltage across a p-n junction in a long article published in 1949. [2] Later he gives a corresponding equation for current as a function of voltage under additional assumptions, which is the equation we call the Shockley ideal diode equation. [3]
A diode-OR circuit is used in electronics to isolate two or more voltage sources. There are two typical implementations: There are two typical implementations: When a DC supply voltage needs to be generated from one of a number of different sources, for example when terminating a parallel SCSI bus, a very simple circuit like this can be used:
The diode, a nonlinear device, is in series with a linear circuit consisting of a resistor, R and a voltage source, V DD. The characteristic curve (curved line), representing the current I through the diode for any given voltage across the diode V D, is an exponential curve.
Diode–transistor logic (DTL) is a class of digital circuits that is the direct ancestor of transistor–transistor logic. It is called so because the logic gating functions AND and OR are performed by diode logic , while logical inversion (NOT) and amplification (providing signal restoration) is performed by a transistor (in contrast with ...
p–n junctions represent the simplest case of a semiconductor electronic device; a p-n junction by itself, when connected on both sides to a circuit, is a diode. More complex circuit components can be created by further combinations of p-type and n-type semiconductors; for example, the bipolar junction transistor (BJT) is a semiconductor in ...
The word diode however was already in use, as were triode, tetrode, pentode, hexode, as terms of multiplex telegraphy. [23] Although all diodes rectify, "rectifier" usually applies to diodes used for power supply, to differentiate them from diodes intended for small signal circuits.