Ads
related to: inoculating loop wire plastic connectors home depot free delivery amounttemu.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
An inoculation loop (also called a smear loop, inoculation wand or microstreaker) is a simple tool used mainly by microbiologists to pick up and transfer a small sample of microorganisms called inoculum from a microbial culture, e.g. for streaking on a culture plate. [1] [2] This process is called inoculation.
The inoculation needle after incineration is cooled down on an uninoculated region of the agar plate culture. [1] Too much heat will kill off the inoculum during the direct contact of a flamed inoculation needle. [1] The inoculation needle is withdrawn from the agar culture after obtaining a small colony and the agar plate lid is then replaced.
The inoculation loop is first sterilized by passing it through a flame. When the loop is cool, it is dipped into an inoculum such as a broth or patient specimen containing many species of bacteria. The inoculation loop is then dragged across the surface of the agar back and forth in a zigzag motion until approximately 30% of the plate has been ...
Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.
Nichrome wire loop: used to inoculate test samples into culture media for bacterial or fungal cultures, antibiograms, etc.; sterilized by flaming to red hot before use Petri dish/agar plate: to act as a supporting container to hold the culture medium in Platinum wire loop
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.