Search results
Results From The WOW.Com Content Network
The selection of the sample rate was based primarily on the need to reproduce the audible frequency range of 20–20,000 Hz (20 kHz). The Nyquist–Shannon sampling theorem states that a sampling rate of more than twice the maximum frequency of the signal to be recorded is needed, resulting in a required rate of greater than 40 kHz.
High-resolution audio (high-definition audio or HD audio) is a term for audio files with greater than 44.1 kHz sample rate or higher than 16-bit audio bit depth. It commonly refers to 96 or 192 kHz sample rates. However, 44.1 kHz/24-bit, 48 kHz/24-bit and 88.2 kHz/24-bit recordings also exist that are labeled HD audio.
In June 2020, Elgato announced their expansion into microphones with the introduction of the Wave:1 and Wave:3. [28] Both are USB microphones and were developed in partnership with Lewitt Audio. In September 2022, they released their first XLR microphone, called Wave DX, once again in cooperation with Lewitt Audio.
Sample-rate conversion prevents changes in speed and pitch that would otherwise occur when transferring recorded material between such systems. More specific types of resampling include: upsampling or upscaling; downsampling, downscaling, or decimation; and interpolation. The term multi-rate digital signal processing is sometimes used to refer ...
Sample accuracy/synchronisation Not as much a specification as an ability. Since independent digital audio devices are each run by their own crystal oscillator, and no two crystals are exactly the same, sample rate will be slightly different. This will cause the devices to drift apart over time.
For most phonemes, almost all of the energy is contained in the 100 Hz – 4 kHz range, allowing a sampling rate of 8 kHz. This is the sampling rate used by nearly all telephony systems, which use the G.711 sampling and quantization specifications. [citation needed]
CD audio, for example, has a sampling rate of 44.1 kHz (44,100 samples per second), and has 16-bit resolution for each stereo channel. Analog signals that have not already been bandlimited must be passed through an anti-aliasing filter before conversion, to prevent the aliasing distortion that is caused by audio signals with frequencies higher ...
The simplest way to change the duration or pitch of an audio recording is to change the playback speed. For a digital audio recording, this can be accomplished through sample rate conversion. When using this method, the frequencies in the recording are always scaled at the same ratio as the speed, transposing its perceived pitch up or down in ...