Search results
Results From The WOW.Com Content Network
Stripboard is the generic name for a widely used type of electronics prototyping material for circuit boards characterized by a pre-formed 0.1 inches (2.54 mm) regular (rectangular) grid of holes, with wide parallel strips of copper cladding running in one direction all the way along one side of an insulating bonded paper board.
Similarly, the strip lay-out must be determined (strip width and pitch). The bridge width between the parts and the edge allowance between the part and the edge of the strip also have to be selected. A simple operation may only need a pancake die. While many dies perform complex procedures simultaneously, a pancake die may only perform one ...
Strip-built, or "strip-plank epoxy", is a method of boat building. [1] Also known as cold molding, the strip-built method is commonly used for canoes and kayaks, but also suitable for larger boats. The process involves securing narrow, flexible strips of wood edge-to-edge around temporary formers.
Trimmer potentiometers or "trimpots" A trimmer, or preset, is a miniature adjustable electrical component.It is meant to be set correctly when installed in some device, and never seen or adjusted by the device's user.
MDF (medium-density fiberboard) is a common material used for baseboard trim and molding. It is an engineered wood product manufactured from refined wood fibers combined with wax and resin binders. MDF is denser and more rigid than standard particle board. Compared to solid wood trim, MDF baseboard has the advantage of being consistent in ...
Warship insulation, called Navy Board, was a permanent form-board insulation covered with woven continuous fiber cloth. Owens-Corning produced a prototype boat hull constructed of fiber glass-reinforced plastic in 1944. [11] In 1945, the company worked with an automaker to produce the first fiberglas-reinforced plastic car body.
Diagonal- and stepped-cut rift-sawing is intermediate to flat-sawn and radial cut lumber. The angle of the bastard grain may differ along the width of the board or between opposing sides, and enhances the appearance of ray fleck. Flat-sawing is the quickest method, producing the least wood waste and largest possible boards from a log.
A production board is not to be confused with a stripboard used for electronics prototyping. Historically, strip boards were manually assembled by hand on specially-made multi-panel boards made of vinyl or wood, about 15 to 18 inches tall (38 to 45 cm), whose panels could be easily folded up. [3]