Search results
Results From The WOW.Com Content Network
At high frequencies, the PIN diode appears as a resistor whose resistance is an inverse function of its forward current. Consequently, PIN diode can be used in some variable attenuator designs as amplitude modulators or output leveling circuits. PIN diodes might be used, for example, as the bridge and shunt resistors in a bridged-T attenuator.
A 2-D tetra-lateral PSD is capable of providing continuous position measurement of the incident light spot in 2-D. It consists of a single square PIN diode with a resistive layer. When there is an incident light on the active area of the sensor, photocurrents are generated and collected from four electrodes placed along each side of the square ...
An example is given in the section below on electroacoustics. Sensitivity second definition: the minimum magnitude of input signal required to produce an output signal with a specified signal-to-noise ratio of an instrument or sensor. Examples of the use of this definition are given in the sections below on receivers and electronic sensors.
Also called CLDs, constant-current diodes, diode-connected transistors, or current-regulating diodes. Crystal rectifiers or crystal diodes These are point-contact diodes. [27] The 1N21 series and others are used in mixer and detector applications in radar and microwave receivers. [24] [25] [26] The 1N34A is another example of a crystal diode. [38]
Tunnel diodes and Gunn diodes are examples of components that have negative resistance. Hysteresis vs single-valued: Devices which have hysteresis; that is, in which the current–voltage relation depends not only on the present applied input but also on the past history of inputs, have I–V curves consisting of families of closed loops. Each ...
[citation needed] For example, the internal structure of an NPN bipolar transistor resembles two P-N junction diodes connected together by a common anode. In normal operation the base-emitter junction does indeed form a diode, but in most cases it is undesirable for the base-collector junction to behave as a diode.
In photoconductive mode the diode is reverse biased, that is, with the cathode driven positive with respect to the anode. This reduces the response time because the additional reverse bias increases the width of the depletion layer, which decreases the junction's capacitance and increases the region with an electric field that will cause ...
To drive the LED, a computer-controlled pin is turned on and off at the right time. Cross-talk from the LED to the receiving PIN diode is extreme, so the protocol is half-duplex. To receive, an external interrupt bit is started by the start bit, then polled a half-bit time after following bits.