Ad
related to: jeep dana 30 axle inner seal torque specs specifications
Search results
Results From The WOW.Com Content Network
The Dana/Spicer Model 30 is an automotive axle manufactured by Dana Holding Corporation. It has been manufactured as a beam axle and independent suspension axle with several versions. 2011 Jeep Dana 30 differential Jeep Dana 30
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20. Almost all Dana 18 and Dana 20 input gears are 6-spline; the only exception is the one used with the 10-spline version of the T14 transmission.
The Dana/Spicer Model 60 is an automotive axle manufactured by Dana Holding Corporation and used in OEM pickup and limited passenger car applications by Chevrolet, Dodge, Chrysler, Jeep, Ford and Land Rover. There are front and rear versions of the Dana 60.
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
1996–1999: Dana 30, high pinion, reverse cut, 297x/760 universal joint, 27-spline axle shafts 2000–2001: Dana 30, low pinion, standard cut, 297x/760 universal joint, 27-spline axle shafts 1985–2001: straight non-driven front axle for two-wheel drive only
The clutch pack applies progressive 0 to 100% locking between the front and rear output shafts. For example, if the rear axle starts rotating at a significantly higher rate than the front axle, the gerotor pump causes the clutch pack to progressively lock, transferring torque to the front axle until both axles are driven at the same speed. The ...
Jeep CJ; Jeep Wagoneer/Grand Wagoneer; Kaiser Jeep was purchased by AMC in 1970. The Buick 350 cu in (5.7 L) V8, AMC 232 I6, and AMC 327, 360 V8 engines in the FSJ Wagoneer and trucks used a 'nailhead' pattern TH400—also known as a "unipattern," as it was used by many other manufacturers (including Rolls-Royce and Jaguar) with an adapter ring—from 1965 to 1972.