Ads
related to: basic latching circuit
Search results
Results From The WOW.Com Content Network
The circuit shown below is a basic NAND latch. The inputs are also generally designated S and R for Set and Reset respectively. Because the NAND inputs must normally be logic 1 to avoid affecting the latching action, the inputs are considered to be inverted in this circuit (or active low).
A latching relay, also called impulse, bistable, keep, or stay relay, or simply latch, maintains either contact position indefinitely without power applied to the coil. The advantage is that one coil consumes power only for an instant while the relay is being switched, and the relay contacts retain this setting across a power outage.
This control signal could be generated by a simple circuit, with its inputs being the present output, input and the state of the clock (high or low). If the output of the flip-flop is low, and a high clock pulse is applied with the input being a low pulse, then there is no need for a state transition.
This latch configuration is a common idiom in ladder logic. It may also be referred to as seal-in logic. The key to understanding the latch is in recognizing that the "Start" switch is a momentary switch (once the user releases the button, the switch is open again).
When the gate current is discontinued, if the current between the two main terminals is more than what is called the latching current, the device continues to conduct. Latching current is the minimum current that keeps the device internal structure latched in the absence of gate current.
The schematic diagrams for relay logic circuits are often called line diagrams, because the inputs and outputs are essentially drawn in a series of lines. A relay logic circuit is an electrical network consisting of lines, or rungs, in which each line or rung must have continuity to enable the output device. A typical circuit consists of a ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A vacuum tube Abraham-Bloch multivibrator oscillator, France, 1920 (small box, left).Its harmonics are being used to calibrate a wavemeter (center).. The first multivibrator circuit, the classic astable multivibrator oscillator (also called a plate-coupled multivibrator) was first described by Henri Abraham and Eugene Bloch in Publication 27 of the French Ministère de la Guerre, and in ...