Search results
Results From The WOW.Com Content Network
Building a palisade wall for the fort at Jamestown, Virginia The Golden Plow Tavern in York, PA, is a very unusual American building. It is built with corner post construction on the ground floor, half-timbered style of timber framing on the upper floor and has a less common style of wood roof shingles than typical in America.
Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used for sheathing buildings and to construct concrete formwork. A strong joint, the tongue and groove joint is widely used for re-entrant angles
39 in (990 mm) wainscoting using 3 in (76 mm) tongue and groove pine boards. Panelling (or paneling in the United States) is a millwork wall covering constructed from rigid or semi-rigid components. [1] These are traditionally interlocking wood, but could be plastic or other materials.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Bed-mould or bed moulding: Narrow moulding used at the junction of a wall and ceiling, found under the cornice, of which it is a part. [2] Similar to crown moulding, a bed mould is used to cover the joint between the ceiling and wall. Bed moulds can be either sprung or plain, or flush to the wall as an extension of a cornice mould. [3]
Exterior walls [ edit ] Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm ( 3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm ( 3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [ 1 ]
Vigas and latillas in the ceiling of San Francisco de Asis Mission Church, Ranchos de Taos, New Mexico The exterior of the same building showing the projecting vigas Bandelier National Monument Headquarters, originally the Park Lodge Dining room and snack-bar building, built by the Civilian Conservation Corps Latillas in a viga roof
Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster. The technique derives from an earlier, more primitive process called wattle and daub. [1]