Search results
Results From The WOW.Com Content Network
Drive: This command-line argument specifies the drive letter of the disk for which to display the volume label and serial number. Note: On Windows, the volume serial number is displayed only for disks formatted with MS-DOS version 4.0 or later. OS/2 allows the user to specify more than one drive. The vol command displays the volume labels ...
Management Data Input/Output (MDIO), also known as Serial Management Interface (SMI) or Media Independent Interface Management (MIIM), is a serial bus defined for the Ethernet family of IEEE 802.3 standards for the Media Independent Interface, or MII. The MII connects media access control (MAC) devices with Ethernet physical layer (PHY ...
Mode Command With Data Word (Broadcast). The Bus Controller sends one command word with a Terminal address of 31 signifying a broadcast type command and a sub-address of 0 or 31 signifying a Mode Code type command, immediately followed by one Data word. No Remote Terminals will respond. The Command Word is built as follows.
The version included with MS-DOS 4 and PC DOS 4 is no longer a simple command-line utility, but a full-fledged installer. The command is available in MS-DOS versions 3.3 and 4 and IBM PC DOS releases 3 through 4. [1] This command is no longer included in DOS Version 5 and later, where it has been replaced by SETUP.
During a command mode operation, the modem may send responses back to the computer indicating the outcome of the command. For example, the modem may respond with the word "BUSY" in response to the ATDT command, if it hears a busy signal after dialing and is configured to listen for busy signals.
Serial numbers are often used in network protocols. However, most sequence numbers in computer protocols are limited to a fixed number of bits, and will wrap around after sufficiently many numbers have been allocated. Thus, recently allocated serial numbers may duplicate very old serial numbers, but not other recently allocated serial numbers.
The command syntax shows some characters in a mixture of upper and lower case. Abbreviating the command to only sending the upper case has the same meaning as sending the upper and lower case command. [3] For example, the command “SYSTem:COMMunicate:SERial:BAUD 2400” would set an RS-232 serial communications interface to 2400 bit/s.
Command Prompt, also known as cmd.exe or cmd, is the default command-line interpreter for the OS/2, [1] eComStation, ArcaOS, Microsoft Windows (Windows NT family and Windows CE family), and ReactOS [2] operating systems.