Search results
Results From The WOW.Com Content Network
ASi-5 uses a novel communication method. The new ASi-5 technology allows the use of ASi-3 components together with components of the new ASi-5 technology on a common cable. If ASi-3 devices are to be used together with ASi-5 components, then in addition to the corresponding devices the use of a new ASi-3 / ASi-5 master is required.
The ASI output of a DVB Integrated Receiver/Decoder (IRD). It carries the entire MPEG transport stream being received from a DVB satellite feed entering the RF input (far left side in picture). Asynchronous Serial Interface , or ASI, is a method of carrying an MPEG Transport Stream ( MPEG-TS ) over 75-ohm copper coaxial cable or optical fiber ...
A schematic symbol for Schottky diodes 1N5822 Schottky diode with cut-open packaging. The semiconductor in the center makes a Schottky barrier against one metal electrode (providing rectifying action) and an ohmic contact with the other electrode.
Exar 16550. The 16550 UART (universal asynchronous receiver-transmitter) is an integrated circuit designed for implementing the interface for serial communications.The corrected -A version was released in 1987 by National Semiconductor. [1]
ASIPs can be used as an alternative of hardware accelerators for baseband signal processing [2] or video coding. [3] Traditional hardware accelerators for these applications suffer from inflexibility. It is very difficult to reuse the hardware datapath with handwritten finite-state machines (FSM). The retargetable compilers of ASIPs help the ...
Amorphous silicon (a-Si) is the non-crystalline form of silicon used for solar cells and thin-film transistors in LCDs.. Used as semiconductor material for a-Si solar cells, or thin-film silicon solar cells, it is deposited in thin films onto a variety of flexible substrates, such as glass, metal and plastic.
A 2.5D integrated circuit (2.5D IC) is an advanced packaging technique [1] that combines multiple integrated circuit dies in a single package [2] without stacking them into a three-dimensional integrated circuit (3D-IC) with through-silicon vias (TSVs). [3] The term "2.5D" originated when 3D-ICs with TSVs were quite new and still very difficult.
RCA by 1977 had changed their specification to give 2.5 for the minimum magnitude of the small-signal gain at f = 1 MHz, essentially giving a minimum f T of 2.5 MHz (and 4 MHz for their MJ2955). Modern 2N3055 datasheets often, but not always, specify f T of 2.5 MHz (minimum) because some improvements have been made over time (especially the ...