Search results
Results From The WOW.Com Content Network
The steam then either travels directly along and down a steam pipe to the engine unit or may first pass into the wet header of a superheater, the role of the latter being to improve thermal efficiency and eliminate water droplets suspended in the "saturated steam", the state in which it leaves the boiler. On leaving the superheater, the steam ...
A high-pressure steam locomotive is a steam locomotive with a boiler that operates at pressures well above what would be considered normal for other locomotives. Most locomotives operate with a steam pressure of 200 to 300 psi (1.38 to 2.07 MPa). [1] In the later years of steam, boiler pressures were typically 200 to 250 psi (1.38 to 1.72 MPa).
Most powerful steam locomotive ever static tested. PRR S1: Pennsylvania Railroad: 6100 Altoona Works: 1939 Steam 6-4-4-6: 487 tonnes (537 short tons) 76,403 pounds-force (340 kN) 7,200 horsepower (5,369 kW) Fast passenger steam locomotive; the magazine Popular Mechanics cites 1941 a speed of 133.4 mph (214.7 km/h) PRR S2: Pennsylvania Railroad ...
Steam under pressure is converted into mechanical energy more efficiently if it is used in a compound engine; in such an engine steam from a boiler is used in high-pressure (HP) cylinders and then under reduced pressure in a second set of cylinders. The lower-pressure steam occupies a larger volume and the low-pressure (LP) cylinders are larger ...
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
This will give evenly spaced exhausts when the engine is working compound. Two arrangements are also possible on a four-cylinder engine: all four cranks set at 90 degrees. With this arrangement the cylinders act in pairs, so there are four impulses per revolution, as with a two-cylinder engine. Most four-cylinder engines are of this type.
Tom Thumb was the first American-built steam locomotive to operate on a common-carrier railroad.It was designed and constructed by Peter Cooper in 1829 to convince owners of the newly formed Baltimore and Ohio Railroad (B&O) (now CSX) to use steam engines; it was not intended to enter revenue service.
A steam engine is a heat engine that performs mechanical work using steam as its working fluid. The steam engine uses the force produced by steam pressure to push a piston back and forth inside a cylinder. This pushing force can be transformed by a connecting rod and crank into rotational force for work.