Ads
related to: schlage keys cut by number
Search results
Results From The WOW.Com Content Network
A bit key with its main parts labelled. Bitting is the depth of key cuts on a cylinder key for a pin tumbler lock, often expressed as a number. Bitting also refers to the combination of key cuts on a bit key for a warded lock or lever tumbler lock. The exact geometry of modern keys is usually described by a code system. [1]
Schlage (/ ʃ l eɪ ɡ / SHLAYG) [1] [2] is an American lock manufacturer founded in 1920 by Walter Schlage. Schlage was headquartered in San Francisco from its inception until it relocated to Colorado Springs, Colorado, in 1997. Schlage also produces high-security key and cylinder lines Primus, Everest, and Everest Primus XP.
Each number in the bitting code corresponds to a cut on the key blade. For example, a bitting code of 11111 with Depth and Spacing Number 46 specifies a Kwikset key with five shallow cuts. Conversely, a bitting code of 77777 and Depth with Spacing Number 46 specifies a Kwikset key with five deep cuts. Experienced locksmiths might be able to ...
Key cut A square, rounded or V-shaped depression, filed or machined into a key, to allow the key to turn in its lock. In pin tumbler locks, the series of key cuts on a key causes the pins to line up at the shear line or gate so the lock will open. In warded locks, the key cuts bypass the wards so the key can push or pull the bolt. [6] Key pin
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
Thus locksmithing, as its name implies, is the assembly and designing of locks and their respective keys by hand. Most locksmiths use automatic and manual cutting tools to mould keys; most are power tools having battery or mains electricity as their power source.
Interchangeable cores require a notch at the tip of each key to properly align the peaks and valleys of each blade with the combinating pins in the chambers of the mechanism; as a consequence, these keys are always configured and cut from blade tip to bow. Conversely, conventional cylinders and removable cores use a shoulder near the bow of ...
Most wafer tumbler locks with poor tolerances can be opened with a set of jigglers or try-out keys. These sets of keys are designed with the most common patterns of key available. The key is inserted into the lock like a normal key, and a turning force is applied whilst the key is raked back and forth until the lock opens.