Ads
related to: keytrak edge remote automotive sensor kit instructions
Search results
Results From The WOW.Com Content Network
A remote control for a keyless entry system built into an ignition key: pressing a button on the key unlocks the car doors, while another button locks the car and activates its alarm system. A remote keyless system (RKS), also known as remote keyless entry (RKE) or remote central locking, is an electronic lock that controls access to a building ...
A remote starter is a radio controlled device, which is installed in a vehicle by the factory or an aftermarket installer to preheat or cool the vehicle before the owner gets into it. [1] Once activated, by pushing a button on a special key chain remote, it starts the vehicle automatically for a predetermined time.
The SAE J2716 SENT (Single Edge Nibble Transmission) protocol [1] is a point-to-point scheme for transmitting signal values from a sensor to a vehicle controller. It is intended to allow for transmission of high resolution data with a low system cost.
These are intended for use in developing remote sensor nodes, to control relays, or whatever is needed. The USB stick uses an AT90USB1287 for connections to a USB host and to the 2.4 GHz wireless links. These are intended to monitor and control the remote nodes, relying on host power rather than local batteries.
EFI Automotive, previously Electricfil, is a French manufacturer of automotive engines and powertrain sensors. The company is headquartered in Beynost , France, and has factories in Joinville, [ 1 ] China (Wuhan [ 2 ] ), Turkey (Istanbul [ 3 ] ) and the United States (Alabama [ 4 ] ).
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
The CAN protocol was developed by Bosch for automotive and industrial control. Unlike other OBD protocols, variants are widely used outside of the automotive industry. While it did not meet the OBD-II requirements for U.S. vehicles prior to 2003, as of 2008 all vehicles sold in the US are required to implement CAN as one of their signaling ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Ad
related to: keytrak edge remote automotive sensor kit instructions