Ads
related to: stainless steel 1 inch strips of wood on wall with metal roof and trim
Search results
Results From The WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
The wall or ceiling finishing process begins with wood or metal laths. These are narrow strips of wood, extruded metal, or split boards, nailed horizontally across the wall studs or ceiling joists. Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 ...
Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.
Rear styling now featured elongated quarter extensions against which the taillamps, bumper and bumper trim fascia fit flush. Also new was grooved six-inch wide rocker molding made of stainless steel/aluminum composite with a single-rib accent groove. For 1987, new hydro-elastic engine mounts were used to further isolate powertrain vibration.
The most notable styling touch was an extreme notchback roofline. The Eldorado "Biarritz" model featured a stainless-steel roof cap (similar to the 1957–1958 Eldorado Brougham), wider chrome trim along the top of the doors and rear quarter glass, and additional fender spear moldings.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.