Ad
related to: 2x12 rafter span chart
Search results
Results From The WOW.Com Content Network
Sizes vary according to the I-joist's intended load and span. Depths can range from 9 + 1 ⁄ 4 to 24 inches (230–610 mm) and reach up to 80 feet (24 m) in length, although 40 to 42 feet (12–13 m) is more common. The intended use for an I-joist is for floor and roof joists, wall studs, and roof rafters in both residential and commercial ...
Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°); Roman: the ridge height is 2 ⁄ 9 to 1 ⁄ 3 the span (an angle of 24° to 34°); Common: the rafter length is 3 ⁄ 4 the span (about 48°); Gothic: the rafters equal the span (60°); and; Elizabethan: the rafters are longer than the span (more than 60°). [7]
The LH- and DLH-Series have been designed for the purpose of extending the use of joists to spans and loads in excess of those covered by Open Web Steel Joists, K-Series. LH-Series Joists have been standardized in depths from 18 inches (460 mm) through 48 inches (1,200 mm), for spans through 96 feet (29,000 mm).
Hammer beam trusses can have a single hammerbeam or multiple hammerbeams. A false hammerbeam roof (truss) has two definitions: 1) There is no hammer post on the hammer beam [16] [17] as sometimes found in a type of arch brace truss [18] or; 2)The hammer beam joins into the hammer post instead of the hammer post landing on the hammer beam. [19]
By supporting the rafters they allow longer spans than the rafters alone could span, thus allowing a wider building. Purlin plates are very commonly found in large old barns in North America. A crown plate has similarities to a purlin plate but supports collar beams in the middle of a timber-framed building.
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
Nowadays, subfloors are generally made from at least two layers of moisture-resistant ("AC" grade, one side finished and sanded flat) plywood or composite sheeting, jointly also termed Underlayments on floor joists of 2x8, 2x10, or 2x12's (dimensional lumber) spaced generally on 16-inch (40.6 cm) centers, in the United States and Canada. Some ...
First developed in the 1960s, they have become the most common form of enclosure for spans of 20 to 60 meters. [2] Because of these very strong and rigid joints, some of the bending moment in the rafters is transferred to the columns. This means that the size of the rafters can be reduced or the span can be increased for the same size rafters.