Search results
Results From The WOW.Com Content Network
Eccentric bottom bracket on a Burley tandem bicycle held in place with two set screws. The term is also used to refer to the device often used on tandem bicycles with timing chains, single-speed bicycles with a rear disc brake or an internal-geared hub, or any bicycle with vertical dropouts and no derailleur, to allow slight repositioning, fore and aft, of a bottom bracket to properly tension ...
The balance shaft runs off the small gear on the left (the large gear is for the camshaft, causing it to rotate at half the speed of the crankshaft). Balance shafts are often used in inline-four engines , to reduce the second-order vibration (a vertical force oscillating at twice the engine RPM ) that is inherent in the design of a typical ...
The engine has a single rotor that spins on an eccentric shaft in a peritrochoid (Mazda uses an epitrochoid) housing. [38] Since the stationary/rotor gears ratio is 2:3, the rotor rotates by 360° every three rotations of the crankshaft. The eccentric shaft runs on plain bearings, [38] which were better than rollers for heat dissipation ...
The rotor spins around its center and around the axis of the eccentric shaft in a hula hoop fashion, resulting in the rotor making one complete revolution for every three revolutions of the eccentric shaft. In the KKM engine, torque is taken off the eccentric shaft, [4] making it a much simpler design to be adopted to conventional powertrains. [5]
The eccentric shaft, whose position is controlled by the DME using an electric motor, rotates through a range of 225 degrees to push the intermediate arm towards, or away from, the camshaft. For lesser lift, the eccentric shaft moves the intermediate arm away from the camshaft, so that lesser of the camshaft profile is pressing on the ...
These bearings are assembled by placing the inner ring into an eccentric position relative to the outer ring, with the two rings in contact at one point, resulting in a large gap opposite the point of contact. The balls are inserted through the gap and then evenly distributed around the bearing assembly, causing the rings to become concentric.
The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting rods. [4] A flywheel is often attached to one end of the crankshaft, in order to smoothen the power delivery and reduce ...
The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion. The perimeter of this disc is geared to a stationary ring gear and has a series of output shaft pins or rollers placed through the face of the disc. These output shaft pins directly drive the output shaft as the cycloidal disc ...