Search results
Results From The WOW.Com Content Network
The stall zone for the single axial fan and axial fans operated in parallel are shown in the figure. [4] The Figure shows the Stall Prone Areas differently for One fan and Two fans in parallel. [4] The following can be inferred from the graph : For the Fans operated in parallel, the performance is less when compared to the individual fans.
The axial fan is often contained within a short section of cylindrical ductwork, to which inlet and outlet ducting can be connected. Axial fan types have fan wheels with diameters that usually range from less than a foot (0.3 meters) to over 30 feet (9.1 m), although axial cooling tower fan wheels may exceed 82 feet (25 m) in diameter.
These motors are sometimes called DC motors, sometimes EC motors and occasionally DC/EC motors. DC stands for direct current and EC stands for electronically commutated.. DC motors allow the speed of the fans within a fan coil unit to be controlled by means of a 0-10 Volt input control signal to the motor/s, the transformers and speed switches associated with AC fan coils are not required.
This type of fan is used in a wide variety of applications, ranging from small cooling fans for electronics to the giant fans used in cooling towers. Axial flow fans are applied in air conditioning and industrial process applications. Standard axial flow fans have diameters of 300–400 mm or 1,800–2,000 mm and work under pressures up to 800 ...
Figure 1: Components of a centrifugal fan An external motor belt driven inline centrifugal fan discharging inline to the exterior of a building through a duct. Unlike non-inline/non-concentric impeller casing design with a cutoff blade above, the concentrically symetric cylinder casing and impeller geometry of inline type redirects the outflow around so that it is parallel to the inflow of gases.
A pneumatic thermostat is a thermostat that controls a heating or cooling system via a series of air-filled control tubes. This "control air" system responds to the pressure changes (due to temperature) in the control tube to activate heating or cooling when required.
An internal fan-cooled electric motor (colloquially, fan-cooled motor) is a self cooling electric motor.Fan cooled motors feature an axial fan attached to the rotor of the motor (usually on the opposite end as the output shaft) that spins with the motor, providing increased airflow to the motor's internal and external parts which aids in cooling.
They apply to pumps, fans, and hydraulic turbines. In these rotary implements, the affinity laws apply both to centrifugal and axial flows. The laws are derived using the Buckingham π theorem. The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at ...