When.com Web Search

  1. Ads

    related to: what is phase cut dimming switch for ceiling fan

Search results

  1. Results From The WOW.Com Content Network
  2. Voltage controller - Wikipedia

    en.wikipedia.org/wiki/Voltage_controller

    A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...

  3. Phase-fired controller - Wikipedia

    en.wikipedia.org/wiki/Phase-fired_controller

    Phase-fired control (PFC), also called phase cutting or phase-angle control, is a method for power limiting, applied to AC voltages. [1] It works by modulating a thyristor , SCR , triac , thyratron , or other such gated diode -like devices into and out of conduction at a predetermined phase angle of the applied waveform.

  4. Dimmer - Wikipedia

    en.wikipedia.org/wiki/Dimmer

    Semiconductor dimmers switch on at an adjustable time (phase angle) after the start of each alternating-current half-cycle, thereby altering the voltage waveform applied to lamps and so changing its RMS effective value. Because they switch instead of absorbing part of the voltage supplied, there is very little wasted power.

  5. Ceiling fan - Wikipedia

    en.wikipedia.org/wiki/Ceiling_fan

    This was a dial mounted either on the body of the fan or in a gang box at the wall, and when turned in either direction, continuously varied the speed at which the blades rotated—similar to a dimmer switch for a light fixture. A few fans substituted a rotary click-type switch for the infinite-speed dial, providing a set number of set speeds ...

  6. 0-10 V lighting control - Wikipedia

    en.wikipedia.org/wiki/0-10_V_lighting_control

    The switch is controlled by a PWM (Pulse Width Modulation) signal, which alternately turns the switch on and off at a rapid rate. The relative proportion of off time vs. on time determines brightness. For example, if the switch is off 10% of the time, the resulting control signal would be the equivalent of 1 V produced with a variable resistor.

  7. Light switch - Wikipedia

    en.wikipedia.org/wiki/Light_switch

    Two light switches in one box. The switch on the right is a dimmer switch. The switch box is covered by a decorative plate. The first light switch employing "quick-break technology" was invented by John Henry Holmes in 1884 in the Shieldfield district of Newcastle upon Tyne. [1]