Search results
Results From The WOW.Com Content Network
The boot code in the VBR can assume that the BIOS has set up its data structures and interrupts and initialized the hardware. The code should not assume more than 32 KB of memory to be present for fail-safe operation; [1] if it needs more memory it should query INT 12h for it, since other pre-boot code (such as f.e. BIOS extension overlays, encryption systems, or remote bootstrap loaders) may ...
In Microsoft Windows, the MBR boot code tries to find an active partition (the MBR is only 512 bytes), then executes the VBR boot code of an active partition. The VBR boot code tries to find and execute the bootmgr file from an active partition. [3] On systems with UEFI firmware, UEFI invokes bootmgfw.efi from an EFI system partition at startup ...
[4] [10] If the loaded boot sector is a PC DOS 3.3 (or newer) VBR, the requirements are slightly relaxed. The system files still have to be stored in the first two root directory entries on the disk, but the VBR will use only the first entry to load the first three sectors of IBMBIO.COM into memory and transfer control to it.
The DAO bug. On June 17, 2016, the DAO was subjected to an attack exploiting a combination of vulnerabilities, including the one concerning recursive calls, that resulted in the transfer of 3.6 million Ether – around a third of the 11.5 million Ether that had been committed to The DAO – valued at the time at around $50M.
In all versions of Windows 9x except ME, it is also possible to load Windows by booting to a DOS prompt and typing "win". There are some command line switches that can be used with the WIN command: with the /D switch, Windows boots to safe mode, and with the /D:n switch, Windows boots to safe mode
In computing, the BIOS parameter block, often shortened to BPB, is a data structure in the volume boot record (VBR) describing the physical layout of a data storage volume. On partitioned devices, such as hard disks , the BPB describes the volume partition, whereas, on unpartitioned devices, such as floppy disks , it describes the entire medium.
Though NTLDR can boot DOS and non-NT versions of Windows, boot.ini cannot configure their boot options. For NT-based OSs, the location of the operating system is written as an Advanced RISC Computing (ARC) path. boot.ini is protected from user configuration by having the following file attributes: system, hidden, read-only.
Microsoft boot sectors, therefore, traditionally imposed certain restrictions on the boot process. For example, the boot file had to be located at a fixed position in the root directory of the file system and stored within consecutive sectors, [7] [8] conditions taken care of by the SYS command and slightly relaxed in later versions of DOS.