Search results
Results From The WOW.Com Content Network
Net indicated mean effective pressure (IMEP) is calculated using the indicated power; i.e., the pressure volume integral in the work per cycle equation. Sometimes the term FMEP (friction mean effective pressure) is used as an indicator of the mean effective pressure lost to friction (or friction torque) and is just the difference between IMEP ...
The brake balance or brake bias of a vehicle is the distribution of brake force at the front and rear tires, and may be given as the percentage distributed to the front brakes (e.g. 52%) [1] or as the ratio of front and rear percentages (e.g. 52/48). [2]
The type of brake system in use only affects trucks and large mass vehicles, which cannot supply enough force to match the static frictional force. [1] [Note 2] The braking distance is one of two principal components of the total stopping distance. The other component is the reaction distance, which is the product of the speed and the ...
In a nozzle or other constriction, the discharge coefficient (also known as coefficient of discharge or efflux coefficient) is the ratio of the actual discharge to the ideal discharge, [1] i.e., the ratio of the mass flow rate at the discharge end of the nozzle to that of an ideal nozzle which expands an identical working fluid from the same initial conditions to the same exit pressures.
To calculate the actual efficiency of an engine requires the energy density of the fuel being used. Different fuels have different energy densities defined by the fuel's heating value. The lower heating value (LHV) is used for internal-combustion-engine-efficiency calculations because the heat at temperatures below 150 °C (300 °F) cannot be ...
British Railway Class 90 infobox showing brake force Brake force to weight ratio of the Class 67 is higher than some other locomotives. In the case of railways, it is important that staff are aware of the brake force of a train so sufficient brake power will be available to bring the train to a halt within the required distance from a given speed.
The mass imbalance is often also used for control of the outer loop. The name of this class of methods stems from the fact that the correction of the velocity field is computed through the pressure-field. The discretization of this is typically done with either the finite element method or the finite volume method. With the latter, one might ...
The formula was calculated from total piston surface area (i.e., "bore" only). The factor of 2.5 accounts for characteristics that were widely seen in engines at the time, such as a mean effective pressure in the cylinder of 90 psi (6.2 bar) and a maximum piston speed of 1,000 feet per minute (5.1 m/s).