Search results
Results From The WOW.Com Content Network
The technique is closely related to using gas adsorption to measure pore sizes, but uses the Gibbs–Thomson equation rather than the Kelvin equation.They are both particular cases of the Gibbs Equations of Josiah Willard Gibbs: the Kelvin equation is the constant temperature case, and the Gibbs–Thomson equation is the constant pressure case. [1]
When pressure and temperature are variable, only of components have independent values for chemical potential and Gibbs' phase rule follows. The Gibbs−Duhem equation cannot be used for small thermodynamic systems due to the influence of surface effects and other microscopic phenomena. [2]
The Gibbs adsorption isotherm for multicomponent systems is an equation used to relate the changes in concentration of a component in contact with a surface with changes in the surface tension, which results in a corresponding change in surface energy. For a binary system, the Gibbs adsorption equation in terms of surface excess is
In solution chemistry and biochemistry, the Gibbs free energy decrease (∂G/∂ξ, in molar units, denoted cryptically by ΔG) is commonly used as a surrogate for (−T times) the global entropy produced by spontaneous chemical reactions in situations where no work is being done; or at least no "useful" work; i.e., other than perhaps ± P dV.
Two methods to extract the Gibbs free energy based on the value of CMC and exist; Phillips method [3] based on the law of mass action and the pseudo-phase separation model. The law of mass action postulates that the micelle formation can be modeled as a chemical equilibrium process between the micelles M n {\displaystyle M_{n}} and its ...
When both temperature and pressure are held constant, and the number of particles is expressed in moles, the chemical potential is the partial molar Gibbs free energy. [ 1 ] [ 2 ] At chemical equilibrium or in phase equilibrium , the total sum of the product of chemical potentials and stoichiometric coefficients is zero, as the free energy is ...
This equation has been derived in the case of reversible changes. However, since U , S , and V are thermodynamic state functions that depend on only the initial and final states of a thermodynamic process, the above relation holds also for non-reversible changes.
In thermodynamics, the Gibbs free energy (or Gibbs energy as the recommended name; symbol ) is a thermodynamic potential that can be used to calculate the maximum amount of work, other than pressure–volume work, that may be performed by a thermodynamically closed system at constant temperature and pressure.