Search results
Results From The WOW.Com Content Network
If the boiler is of the high efficiency condensing type, high turndown ratios are feasible and the higher the turndown ratio, the more efficient it will be. Every time a gas/oil boiler stops, it has to be "purged" with cold air to remove any combustible gases that may have accumulated in the boiler before restarting.
Boilers have a turndown ratio which is the ratio of the maximum power output to the minimum power output for which combustion can be maintained. If the control system determines that the demand falls below the minimum power output, then the boiler will cycle off until the water temperature has fallen, and then will reignite and heat the water.
The water is heated and then routed into a reduced-pressure flash evaporation "stage" where some of the water flashes into steam. This steam is subsequently condensed into salt-free water. The residual salty liquid from that first stage is introduced into a second flash evaporation stage at a pressure lower than the first stage pressure.
Here, is the molecular weight of water (vapor), is the average molecular weight of air, is the partial pressure of air (not including the partial pressure of water vapor in an air mixture) and can be approximated by knowing the partial pressure of water vapor at the inlet, before dehumidification occurs, ,. From here, all of the previously ...
A LaMont boiler is a type of forced circulation water-tube boiler [1] in which the boiler water is circulated through an external pump through long closely spaced tubes of small diameter. The mechanical pump is employed in order to have an adequate and positive circulation in steam and hot water boilers.
The boiler heats water to a temperature controlled by a thermostat. The water then flows (either by natural circulation or by a pump) to radiators in the rooms which are to be heated. Water also flows through a coil in the hot water tank to heat a separate mass of water for bathing, etc.
A generic term for water-tube boilers of the Yarrow pattern. In Royal Navy practice, a reference to the specific Admiralty example of this. [4] [5] Throatplate a plate forming the lower front of the outer firebox of a locomotive boiler, below the barrel. Top-feed in locomotive boilers, a feed water check valve placed on the top of the boiler ...
A small tank water heater. Water heating is a heat transfer process that uses an energy source to heat water above its initial temperature. Typical domestic uses of hot water include cooking, cleaning, bathing, and space heating. In industry, hot water and water heated to steam have many uses.