When.com Web Search

  1. Ads

    related to: ethernet jack splitter

Search results

  1. Results From The WOW.Com Content Network
  2. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    The connector commonly used for twisted-pair Ethernet is a non-keyed 8P8C connector, quite distinct from that used for RJ45S. The new ARJ45 interface, however, is a plug and jack allowing higher transmission rates, and the jack can, optionally, be backward-compatible with the common 8P8C plugs of Gigabit Ethernet and earlier standards.

  3. Y-cable - Wikipedia

    en.wikipedia.org/wiki/Y-cable

    A Shure FP24 preamp's mono XLR line outputs connected to an Edirol R-09 recorder's 3.5mm stereo jack line input, using a Y-cable. This is an example of consolidating connectors, as described below. A Y-cable, Y cable, or splitter cable is a cable with three ends: one common end and two other ends.

  4. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    On the plug, the contacts are flat metal bars positioned parallel to the connector body. Inside the jack, the contacts are metal spring wires angled away from the insertion interface. When the plug is mated with the jack, the contacts meet and create an electrical connection. The spring force of the jack contacts ensures a good interface.

  5. Power over Ethernet - Wikipedia

    en.wikipedia.org/wiki/Power_over_Ethernet

    In this configuration, an Ethernet connection includes Power over Ethernet (PoE) (gray cable looping below), and a PoE splitter provides a separate data cable (gray, looping above) and power cable (black, also looping above) for a wireless access point. The splitter is the silver and black box in the middle between the wiring junction box (left ...

  6. StarLAN - Wikipedia

    en.wikipedia.org/wiki/StarLAN

    This greatly simplified the installation of combined voice and data wiring in countries that used registered jack connectors and American wiring practices for their phone service (connecting both to the same cable was a simple matter of using a pin–pin RJ45 splitter or punching down the same wires to two ports).

  7. Ethernet - Wikipedia

    en.wikipedia.org/wiki/Ethernet

    While 1BASE5 had little market penetration, it defined the physical apparatus (wire, plug/jack, pin-out, and wiring plan) that would be carried over to 10BASE-T through 10GBASE-T. The most common forms used are 10BASE-T, 100BASE-TX, and 1000BASE-T. All three use twisted-pair cables and 8P8C modular connectors.