Search results
Results From The WOW.Com Content Network
The system has very high efficiency but, like other evaporative cooling systems, is constrained by the ambient humidity levels, which has limited its adoption for residential use. It may be used as supplementary cooling during times of extreme heat without placing significant additional burden on electrical infrastructure.
When included in a combined thermal insulation, evaporative cooling, and radiative cooling system consisting of "a solar reflector, a water-rich and IR-emitting evaporative layer, and a vapor-permeable, IR-transparent, and solar-reflecting insulation layer," 300% higher [clarification needed] ambient cooling power was demonstrated.
There is evidence that evaporative cooling may have been used in North Africa as early as the Old Kingdom of Egypt, circa 2500 BC. Frescoes show slaves fanning water jars, which would increase air flow around porous jars to aid evaporation and cooling the contents. [3] These jars exist even today. They are called zeer, hence the name of the pot ...
Demonstration of evaporative cooling. When the sensor is dipped in ethanol and then taken out to evaporate, the instrument shows progressively lower temperature as the ethanol evaporates. Rain evaporating after falling on hot pavement. Evaporation is a type of vaporization that occurs on the surface of a liquid as it changes into the gas phase. [1]
Since the cooling towers are based on the principles of evaporative cooling, the maximum cooling tower efficiency depends on the wet bulb temperature of the air. The wet-bulb temperature is a type of temperature measurement that reflects the physical properties of a system with a mixture of a gas and a vapor, usually air and water vapor
During the cooling season, the stack effect is reversed, but is typically weaker due to lower temperature differences. [1] In a modern high-rise building with a well-sealed envelope, the stack effect can create significant pressure differences that must be given design consideration and may need to be addressed with mechanical ventilation ...
By incorporating thermal destratification technology into buildings, energy requirements are reduced as heating systems are no longer over-delivering in order to constantly replace the heat that rises away from the floor area, by redistributing the already heated air from the unoccupied ceiling space back down to floor level, until temperature ...
The albedo of several types of roofs (lower values means higher temperatures). Reflective surfaces, or ground-based albedo modification (GBAM), is a solar radiation management method of enhancing Earth's albedo (the ability to reflect the visible, infrared, and ultraviolet wavelengths of the Sun, reducing heat transfer to the surface).