Search results
Results From The WOW.Com Content Network
In other words, the spring for the rear suspension is a coil spring that is installed over, or around, the shock. In terms of adjustment, rear shocks span the range from no adjustments whatsoever to pre-load adjustments only to racing shocks with adjustments for length, pre-load, and four different kinds of damping. Most shocks have internal ...
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
Height adjustable suspension is a feature of certain automobile suspension systems that allow the motorist to vary the ride height or ground clearance. This can be done for various reasons including giving better ground clearance over rough terrain, a lower ground clearance to improve performance and fuel economy at high speed, [1] or for stylistic reasons.
Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations. The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars.
The package included a total lowered ride height of approximately 2" over stock (1.5" from suspension, ~0.5" from shorter tire diameter), thicker front sway bar (33mm), rear sway bar (23mm), quicker ratio (12:1) steering box, upgraded Decarbon or Bilstein gas shock absorbers, ZQ8 specific bump stops and a frame brace. Some ZQ8 models were also ...
Camber and caster: Some coilover suspension kits may also be supplied with adjustable top mounts. Depending on the design of the car's suspension these top mounts can allow the adjustment of camber and/or caster. Some coilovers use the car's original top mounts and are therefore not adjustable.
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
A coil spring suspension can be stiff to soft depending on the vehicle it is used on. Coil spring can be either mounted with a shock absorber or mounted separately. Coil springs in trucks allow them to ride smoothly when unloaded and once loaded the spring compresses and becomes stiff. This allows the vehicle to bounce less when loaded.