When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. ESP8266 - Wikipedia

    en.wikipedia.org/wiki/ESP8266

    SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...

  3. ESP32 - Wikipedia

    en.wikipedia.org/wiki/ESP32

    ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...

  4. NodeMCU - Wikipedia

    en.wikipedia.org/wiki/NodeMCU

    NodeMCU DEVKIT 1.0, bottom. NodeMCU is a low-cost open source IoT platform. [4] [5] It initially included firmware which runs on the ESP8266 Wi-Fi SoC from Espressif Systems, and hardware which was based on the ESP-12 module.

  5. Comparison of single-board microcontrollers - Wikipedia

    en.wikipedia.org/wiki/Comparison_of_single-board...

    USB Programming Facilitated by the Ubiquitous FTDI FT231X (more stable). TX, RX, Power, pin 13 LEDs are moved to edge. Utilize USB Micro-B socket. Extra pads with standard 0.1" (2.54 mm) pitch to pitch. CT ARM (Cytron ARM Cortex M0) Cytron Technologies: NUC131LD2AE (32-bit ARM Cortex-M0) 50 MHz Arduino 2.7 in × 2.1 in [ 68.6 mm × 53.3 mm ]

  6. ESP Easy - Wikipedia

    en.wikipedia.org/wiki/ESP_Easy

    The name "ESP Easy," by default, refers to the firmware rather than the hardware on which it runs. [3] [4] At a low level, the ESP Easy firmware works the same as the NodeMCU firmware and also provides a very simple operating system on the ESP8266. The main difference between ESP Easy firmware and NodeMCU firmware is that the former is designed ...

  7. In-system programming - Wikipedia

    en.wikipedia.org/wiki/In-system_programming

    To put the PIC into programming mode, this line must be in a specified range that varies from PIC to PIC. For 5 V PICs, this is always some amount above V dd , and can be as high as 13.5 V. The 3.3 V only PICs like the 18FJ, 24H, and 33F series use a special signature to enter programming mode and V pp is a digital signal that is either at ...

  8. Hardware register - Wikipedia

    en.wikipedia.org/wiki/Hardware_register

    Hardware registers are addressed in words, but sometimes only use a few bits of the word read in to, or written out to the register. Commercial design tools simplify and automate memory-mapped register specification and code generation for hardware, firmware, hardware verification, testing and documentation.

  9. EFI system partition - Wikipedia

    en.wikipedia.org/wiki/EFI_System_partition

    The EFI (Extensible Firmware Interface) system partition or ESP is a partition on a data storage device (usually a hard disk drive or solid-state drive) that is used by computers that have the Unified Extensible Firmware Interface (UEFI). When a computer is booted, UEFI firmware loads files stored on the ESP to start operating systems and ...