Search results
Results From The WOW.Com Content Network
In electronics the amplification factor, or gain, is the ratio of the output to the input of an amplifier, sometimes represented by the symbol A F. In numerical analysis the amplification factor is a number derived using Von Neumann stability analysis to determine stability of a numerical scheme for a partial differential equation .
In most amplifiers a reduction in gain takes place before hard clipping occurs; the result is a compression effect, which (if the amplifier is an audio amplifier) sounds much less unpleasant to the ear. For these amplifiers, the 1 dB compression point is defined as the input power (or output power) where the gain is 1 dB less than the small ...
A gain greater than one (greater than zero dB), that is, amplification, is the defining property of an active device or circuit, while a passive circuit will have a gain of less than one. [4] The term gain alone is ambiguous, and can refer to the ratio of output to input voltage (voltage gain), current (current gain) or electric power (power ...
For transistors, the current-gain–bandwidth product is known as the f T or transition frequency. [4] [5] It is calculated from the low-frequency (a few kilohertz) current gain under specified test conditions, and the cutoff frequency at which the current gain drops by 3 decibels (70% amplitude); the product of these two values can be thought of as the frequency at which the current gain ...
The objective is to find the return ratio of the dependent current source in this amplifier. [9] To reach the objective, the steps outlined above are followed. Figure 2 (center panel) shows the application of these steps up to Step 4, with the dependent source moved to the left of the inserted source of value i t , and the leads targeted for ...
Gain compression is the difference between the ideal linear power transfer curve and the real circuit's power transfer curve. An important gain compression parameter is the OP1dB, which is the power input that results in a 1 dB compression of the output power (OP), corresponding to a gain ratio of 10-1 ⁄ 10 = 79.4%.
In electronics and control system theory, loop gain is the sum of the gain, expressed as a ratio or in decibels, around a feedback loop.Feedback loops are widely used in electronics in amplifiers and oscillators, and more generally in both electronic and nonelectronic industrial control systems to control industrial plant and equipment.
PAE will be very similar to efficiency when the gain of the amplifier is sufficiently high. But if the amplifier gain is relatively low the amount of power that is needed to drive the input of the amplifier should be considered in a metric that measures the efficiency of said amplifier.