Search results
Results From The WOW.Com Content Network
Deep cement mixing consists of using specially designed equipment, such as augers or mixing paddles, to mechanically mix the soil with an in-situ binder. The process simultaneously breaks up the soil without removing it, injects a binder at low pressure and thoroughly mixes the binder with the soil to form a reinforced block of soil after ...
Non-shrink grout is a hydraulic cement grout that, when hardened under stipulated test conditions, does not shrink, so its final volume is greater than or equal to the original installed volume. It is often used as a transfer medium between load-bearing members.
In building construction, concrete uses cement as a binder. Asphalt pavement uses bitumen binder. Traditionally straw and natural fibres are used to strengthen clay in wattle-and-daub construction and in the building material cob which would otherwise become brittle after drying. Sand is added to improve compressive strength, hardness and ...
A static mixer is a device for the continuous mixing of fluid materials, without moving components. [1] Normally the fluids to be mixed are liquid, but static mixers can also be used to mix gas streams, disperse gas into liquid or blend immiscible liquids.
The cement is a hydraulic binder whose hydration requires water. It can perfectly set under water. Water is essential to its hardening and water losses must be avoided at the young age to avoid the development of cracks. Young concrete is protected against desiccation (evaporation of unreacted water). Traditional methods for preventing ...
Leakage in narrow clearance, spool valve. Hydraulic clearance. Flow in narrow clearances are of vital importance in hydraulic system component design. The flow in a narrow circular clearance of a spool valve can be calculated according to the formula below if the height is negligible compared to the width of the clearance, such as most of the clearances in hydraulic pumps, hydraulic motors ...
Hemp concrete has a low thermal conductivity, ranging from 0.06 to 0.6 W m −1 K −1, [24] [15] [25] a total porosity of 68–80% [24] [26] and a density of 200 kg /m 3 to 960 kg/m 3. [ 15 ] [ 27 ] Hemp concrete is also an aerated material with high water vapour permeability and its total porosity very close to open porosity allowing it to ...
The method of making cement from limestone (CaCO 3) and low-silica bauxite (Al 2 O 3) was patented in France in 1908 by Bied of the Pavin de Lafarge Company. The initial development was as a result of the search for a cement offering sulfate resistance. The cement was known as "Ciment fondu" and "Ciment électro-fondu" in French. [2] [3]